b'BRASS PUSH-TO-CONNECT FITTINGS QUICK CONNECTFULL FLOW DESIGNBRASS CONSTRUCTIONFOR USE WITH POLYETHYLENE,NYLON AND POLYURETHANE TUBES.TEE TEE (Plastic) PLUG Ends Tube Ends TubeCenter Male Center Pipe Swivel Female PipePART No.TubePART No.TubePipe PART No.TubePipe PC67-21/8PC72SW-4A1/41/8 PC78-4A1/4 1/8 PC67-41/4PC72SW-4B1/41/4 PC78-4B1/4 1/4 PC67-63/8PC72SW-6B3/81/4 PC78-6B3/8 1/4 PC67-81/2PC72SW-6C3/83/8PC72SW-8D1/21/2ASSEMBLY INSTRUCTIONSTemperature Range -40F to 212F (-40C to 100C)TO CONNECT TUBE: TO DISCONNECT TUBE:Cut plastic as squarely as possible. Insert tube endWith thumb and fore nger, hold down the top of the intotting until friction is felt as tube slides past theinsert against thetting body and then, with the other O-ring. Using a slight twisting motion while insertinghand, pull out the tube. No tools are needed.the tube is often helpful. After this initial friction is felt, continue to push in the tube until it bottomsrmly against the internal tube stop.FAIRVIEW CARRIES A WIDE VARIETY OF TUBE AVAILABLE IN COILSAND REELSSEE SECTION D15'